Metal Roof Repairs

The most common causes we find across Brisbane and the Sunshine Coast are: perished or corroded screw washers that no longer seal around the fastener shank; failed flashings at wall junctions, valleys, cappings, or penetrations; cracked or deteriorated sealant around solar panel mounts, skylights, and vents; lifted or separated ridge and barge capping; sheet laps that allow wind-driven rain entry on low-pitched roofs; and valley or box gutters that overflow during heavy rain and back up under sheeting. Salt air on coastal properties accelerates all of these failure modes.

We carry out a systematic on-roof inspection of every common failure point (fasteners, flashings, laps, cappings, valleys, and penetrations) and work from there. Water rarely travels straight down; it enters through one point and moves along sarking, battens, or sheeting before it appears inside. We trace the water path back to its entry point, photograph what we find, and quote specifically on fixing the source — not just the symptom.

Yes. Colorbond roof repairs across Brisbane and the Sunshine Coast are a significant part of our work. We carry out screw replacement, flashing repairs, sheet replacement, valley repairs, penetration resealing, and ridge and barge capping repairs on Colorbond roofing in all standard profiles. We match Colorbond colours where sheet replacement is needed.

Yes. Roof screw replacement (re-screwing or re-fastening) is one of the most common repairs we carry out. We replace perished washers and corroded fasteners with new corrosion-resistant screws and washers appropriate for the roof type and exposure level. For roofs with widespread washer failure, we re-screw full sections rather than replacing individual screws, which is more cost-effective and prevents multiple repeat call-outs.

Small, targeted repairs, like a flashing reseal, a section of re-screwing, a single sheet replacement, are often completed in a few hours on the same day as the inspection. More complex repairs involving fabricated flashings, valley replacement, or partial resheet work may take a full day or require a follow-up visit for materials. We provide a realistic timeline in the written quote before work starts.

We don't work on wet metal roofing. It's a safety risk. If rain is forecast during a scheduled repair, we'll contact you in advance to reschedule rather than rush the job in marginal conditions. For jobs that extend across multiple days, we leave the roof in a weatherproof condition each day. If weather changes unexpectedly during a job, we secure the work area before coming down.

It depends on the actual condition of the roof. A restoration (clean, prime, seal penetrations and laps, and apply a protective coating) is a cost-effective option for roofs that are structurally sound but weathered. If there's widespread corrosion, multiple sheet failures, or a roof that's past its serviceable life, a re-roof gives you a better return over a five-year horizon. On coastal Sunshine Coast properties, we factor salt air exposure into this assessment, as corrosion can advance the timeline more than expected. We'll give you an honest comparison of both options.

Yes. We carry out metal roof repairs on commercial and industrial buildings across Brisbane and the Sunshine Coast, such us warehouses, sheds, factories, retail properties, and multi-tenancy buildings. Commercial scopes vary significantly, and we have the equipment and experience to work safely at height on large-span roofs. Contact us with the building type and approximate scope and we'll advise on the best approach.